MIL-HDBK-740
(1)
Preliminary procedures
steady stream of cold
(a) Turn cold water valve wheel counterclockwise until water flows through blender and into tank.
(b) Place fingers of one hand into hand access opening
(Item #6, Figure 11) and into stream from blender.
(c) Turn hot water valve wheel counterclockwise slowly until stream from blender is warm to the touch, but not hot enough to burn fingers (maximum 120°F).
(d) Install drain (overflow) pipe (Item #10, Figure 11)
in tank drain opening.
(e) Install scrapping plate (Item #2, Figure 11) on top of tank (Item #9, Figure 11). Turn on switch (Item #18, Figure 11) to start pump motor. If water column from gusher tube (Item #19, Figure 11) does not fall close to center of hole in scrapping plate, adjust pump intake plate (see para. lb Controls). When proper adjustment has been obtained, remove scrapping plate.
(f)
tank. Be sure that insert
(g)
insert on rim of scrapping
d. Operating
(1) Pass
Lower scrap basket (Item #7, Figure 11) into on rim of scrap basket is over gusher tube.
Position scrapping plate on tank, making sure that plate is over gusher tube.
procedures
the soiled tableware and serving trays, bottom
side down, through the water column in such a way that the arc of the stream first strikes the eating surface of the item. Scouring pad, FSN 7920-753-5242, should be used to remove stubborn stains.
(2) Continue the motion through the water column. This will wash both sides of the item, removing most of the debris and grease.
e. Shutdown procedures
(1)
Turn pump motor switch to OFF position.
fully closed.
(2)
(3)
Turn hot and cold water valve wheels clockwise until
Remove scrapping plate and brush any residue from
scrapping plate into
scrap basket.
23
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business